Furnace Not Turning On? A Quick Troubleshooting Checklist
Last reviewed:
Short answer
A furnace that will not turn on is most often caused by a thermostat problem (dead batteries or wrong setting), a tripped breaker or furnace power switch, a loose access panel, a clogged filter that tripped the limit switch, a failed igniter, or a dirty flame sensor. Check the thermostat, power and filter first. If you smell gas, leave the house and call 911 from outside.
Step-by-step checks
Safety first
If you smell rotten eggs (gas) or a CO alarm is sounding, get everyone out and call 911 and your gas company from outside.
Thermostat
Set to HEAT, raise the setpoint a few degrees, and replace the batteries if the screen is dim or blank.
Power
Check the breaker and the furnace power switch, which looks like a light switch on or near the furnace.
Access panel
The blower door has a safety switch. If the panel is not fully seated, the furnace will not run.
Filter
A badly clogged filter can overheat the furnace and trip the high-limit switch. Replace it and try again after a few minutes.
Status light
Most furnaces have a blinking LED. Count the blinks and match the code on the panel label. Give that code to your technician.
Call a technician
Igniters, flame sensors, pressure switches, inducer motors and gas valves need a licensed HVAC tech.
When to stop and call a pro
Stop troubleshooting and call 📞 (330) 704-6386 if you smell gas or burning, a breaker trips more than once, you see sparks or water near electrical parts, or the problem needs refrigerant or electrical work. Those jobs require a licensed technician.
Related questions
Is no heat an emergency?
Yes, when outside temperatures are near or below freezing, when anyone in the home is vulnerable to cold, or when pipes could freeze. Frozen pipes can burst and cause water damage that costs far more than the heating repair.
Why is my furnace blowing cold air?
Common causes are a thermostat set to FAN ON instead of AUTO, a dirty flame sensor that shuts the burners off, a failed igniter, an overheating furnace tripping its limit switch because of a clogged filter, or a gas supply problem.
Why does my furnace click but not turn on?
Clicking without ignition usually points to a failed hot surface igniter, a dirty flame sensor, a gas valve problem or a pressure switch that will not close. These need a licensed technician.
Find emergency furnace & heating repair in your city
Request a fast callback
Prefer to talk now? 📞 Call (330) 704-6386 — answered 24/7.