HVAC guide
Why is my HVAC making noise?
Short answer
Most HVAC noises point to a specific part. Buzzing usually means an electrical problem like a failing capacitor or contactor; banging from a furnace can mean delayed ignition; squealing points to a motor or belt; hissing can mean a refrigerant or duct leak; and repeated clicking often means an ignition or relay issue. Loud banging, grinding or burning smells mean turn the system off and call.
HVAC noise guide
| Sound | Likely cause | What to do |
|---|---|---|
| Single click at start or stop | Normal relay or thermostat switching | Nothing |
| Rapid, repeated clicking | Furnace igniter trying and failing; failing relay or control board | Call for service |
| Buzzing or humming at the outdoor unit | Failing capacitor, stuck contactor, or a motor that can't start | Turn off; call. Don't open the panel; capacitors hold a charge |
| Loud bang or boom when the furnace starts | Delayed ignition: gas builds up before lighting; dirty burners | Shut off and call. This can crack the heat exchanger |
| Squealing or screeching | Worn blower motor bearings or belt; outdoor fan motor | Call soon; motors fail faster once they squeal |
| Grinding or scraping | Failing motor bearings or something hitting the fan | Shut off to prevent motor damage |
| Hissing | Refrigerant leak (outdoor/indoor coil) or air leak in ducts | Call; refrigerant leaks need a licensed tech |
| Gurgling or bubbling | Condensate drain partly clogged or refrigerant flow issue | Check the drain; call if it continues |
| Rattling | Loose panel, screws, debris in the outdoor unit, or ductwork expanding | Tighten panels; clear debris (power off) |
| Whistling at vents or returns | Restricted airflow: dirty filter, closed vents, undersized returns | Change filter; open vents |
What a contactor and a relay do (and why they buzz)
A contactor is the heavy-duty switch inside the outdoor unit. When the thermostat calls for cooling, a low-voltage signal pulls the contactor closed, sending full power to the compressor and fan. Over time the contacts pit and burn. A worn contactor can buzz, chatter, or stick closed so the outdoor unit runs even when the thermostat is off.
Relays do the same job on a smaller scale inside the furnace or air handler, switching the blower and other parts on and off. A faulty relay or control board can cause clicking without the system starting.
Both are inexpensive parts, but they carry line voltage. Replacing them is a job for a licensed technician.
Noises that mean turn it off now
- Loud bangs or booms from the furnace at startup
- Grinding metal, or a screech that keeps getting louder
- Buzzing with a burning or electrical smell
- Any noise along with a carbon monoxide alarm. Leave the house and call 911 from outside
More questions
Is it normal for my heat pump to make a whooshing sound in winter?
Yes. During a defrost cycle the reversing valve shifts with a whoosh, the outdoor fan stops, and the unit may release steam. That's normal. Constant loud noise or a unit that never finishes defrosting is not.
Why does my AC hum but not turn on?
A humming outdoor unit with a fan that won't spin usually means a failed run capacitor or a compressor that can't start. Turn it off to avoid overheating the motor and call for service.
Sources
Related guides
Is your HVAC system safe? Carbon monoxide, fires, mold and air quality
A properly maintained HVAC system is safe. But a gas furnace with a cracked heat exchanger, blocked vent or bad combustion can leak carbon monoxide;…
Learn more →Why won't my furnace turn on?
A furnace that will not turn on is most often caused by a thermostat problem (dead batteries or wrong setting), a tripped breaker or furnace power…
Learn more →What should I do if I smell gas or my carbon monoxide alarm goes off?
If you smell gas or your carbon monoxide alarm goes off, get everyone out of the house immediately, leave the door open behind you, and call 911 and…
Learn more →Request a fast callback
Prefer to talk now? 📞 Call (330) 704-6386 — answered 24/7.